SPDT 1.56 Vista x64 won´t install (BSOD after reboot)

[sonypsx]

Hello,

i ran into some serious troubles.
I installed SPDT v1.56 x64 without success. First step of install went fine. But after the required reboot i went into a BSOD (code 0000007b).
After resuming by "run last good known config" i checked the Reghive for SPDT entries, none of the known does exist. I started again the setup, SPDT installer says - SPDT is not installed. When i try to install again, the same problem exists.

Syspecs: Intel Core i7 920
MaBo: MSI Eclipse SLI
Ram: 12 GB
OS: Vista Ult. x64 SP1 with all patches
Ctrl: Raid 0 on ICH10R with 2 pieces of 500GB HDD´s
Of course latest Intel Matrix Drivers are in place.

Can you please provide me a solution?

Regards
Martin

[Digger]

Do you have any minidump you can send to our support@duplexsecure.com?

[sonypsx]

Hello!

I will do that instantly now.
Hold on for a few minutes ....

Regards Martin

[sonypsx]

Hello!


I´m sorry Windows does just stop with this 0000007B BSOD - no Minidump at all. Double checked the settings!

The only hint i can give is that when i try to Safe Boot then Windows stops after loading the crc32disk.sys

Any suggestions?

Regards Martin